When a load is transferred through one surface to another surface in contact, the stress is known as

Related Questions

• When a load is transferred through one surface to another surface in contact, the stress is known as
• As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
• If fbt and fc are the co-existent bending tensile stress and shear stress in a member, the equivalent stress fc is
• The equivalent axial tensile load Pe, which produces an average axial tensile stress in the section equivalent to the combined stress due to axial tension P and bending M, at the extreme fibre of the section, is given by (where Z is the section modulus of the section).
• The equivalent axial load may be defined as the load which produces a stress equal to
• In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate
• In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate
• Under a concentrated load, bearing stress fb in a beam is given by (where b is the length of the bearing plate and h is the depth of the root of the fillet).
• Under a concentrated load, bearing stress fb in a beam is given by (where b is the length of the bearing plate and h is the depth of the root of the fillet).
• If the area of cross-section of a single angle discontinuous strut is 30 cm2 and allowable working stress corresponding to its slenderness ratio is 625 kg/cm2, the safe load carrying capacity of the member, is