As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor
(i) Dead load 1.7
(ii) Dead Load + imposed load 1.7
(iii) Dead load + load due to wind or 1.3 seismic forces
(iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements

Related MCQs

• The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is
• The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is
• According to IS: 800-1962, the coefficient of expansion of steel per degree centigrade per unit length, is taken as
• According to IS: 800-1962, the coefficient of expansion of steel per degree centigrade per unit length, is taken as
• The maximum permissible slenderness ratio of a member carrying loads resulting from wind, is
• For the buildings having a low permeability, the internal wind pressure acting normal to the wall and roof surfaces is taken as (Where p is basic wind pressure)
• Bearing stiffeners are provided at (i) The supports (ii) The mid span (iii) The point of application of concentrated loads The correct answer is
• Efficiency of a riveted joint, having the minimum pitch as per IS : 800, is
• As per IS : 800, for compression flange, the outstand of flange plates should not exceed
• For the economical design of a combined footing to support two equal column loads, the projections of beams in lower tier are kept such that bending moment under column is equal to