If the area of cross-section of a single angle discontinuous strut is 30 cm2 and allowable working stress corresponding to its slenderness ratio is 625 kg/cm2, the safe load carrying capacity of the member, is

Related MCQs

• As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
• For a steel member of slenderness ratio 350, the allowable stress is 76 kg/cm2 if it is
• For a steel member of slenderness ratio 350, the allowable stress is 76 kg/cm2 if it is
• Allowable working stress corresponding to the slenderness ratio of double angles placed back to back and connected to one side of a gusset plate, is reduced to
• Allowable working stress corresponding to the slenderness ratio of double angles placed back to back and connected to one side of a gusset plate, is reduced to
• An axial loaded column is supported on a slab base whose projection is 8 cm. If the intensity of pressure from concrete is 40 kg/cm2 and allowable bending stress in slab base is 1890 kg/cm2 , the thickness (t) of the slab base, is
• The maximum slenderness ratio of a compression member carrying both dead and superimposed load is
• The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is
• The maximum slenderness ratio of a compression member carrying both dead and superimposed load is
• The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is