- Civil Engineering
- Design of Steel Structures
- Spans of continuous fillers are consider...

Q. |
## Spans of continuous fillers are considered approximately equal if the longest span does not exceed the shortest span by more than |

A. | 5 % |

B. | 10 % |

C. | 15 % |

D. | 20 % |

Answer» C. 15 % |

View all MCQs in:
Design of Steel Structures

- Spans of continuous fillers are considered approximately equal if the longest span does not exceed the shortest span by more than
- The spans are considered approximately equal if the longest span does not exceed the shortest span by more than
- The spans are considered approximately equal if the longest span does not exceed the shortest span by more than
- In case of cantilever fillers, the ratio of the span L to depth d, should not exceed
- The ratio of the span L of the filler joists to the depth d from the underside of the joist to the top of the structural concrete, should not exceed
- The ratio of the span L of the filler joists to the depth d from the underside of the joist to the top of the structural concrete, should not exceed
- Compression members composed of two channels back-to-back and separated by a small distance are connected together by riveting so that the minimum slenderness ratio of each member between the connections, does not exceed
- For a cantilever beam of length continuous at the support and unrestrained against torsion at the support and free at the end, the effective length is equal to
- For a cantilever beam of length continuous at the support and unrestrained against torsion at the support and free at the end, the effective length is equal to
- A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed

Login to Continue

It will take less than 2 minutes

Report MCQ