A simply supported beam deflects by 5 mm when it is subjected to a concentrated load of 10 kN at its centre. What will be deflection in a 1/10 model of the beam if the model is subjected to a 1 kN load at its centre?

Related MCQs

• There are two beams of equal length L and a load P is acting on centre of both beams. One of them is simply supported at both ends while the other one is fixed at both ends. Deflection of centre of simply supported beam will be                      times that of defection of centre of fixed beam.
• If in the above problem in Q5, if load P is excessively increased in simply supported beam, then where would a hinge like point form?
• When a series of wheel loads crosses a simply supported girder, the maximum bending moment under any given wheel load occurs when
• The maximum bending moment due to a train of wheel loads on a simply supported girder
• A fixed beam of the uniform section is carrying a point load at the centre, if the moment of inertia of the middle half portion is reduced to half its previous value, then the fixed end moments will              
• What will be the deflection of beam AB?
• What will be the deflection of beam BC?
• If a beam has 4 external supports, then how many parts would it be divided in case of using slope deflection equations?
• The deflection at any point of a perfect frame can be obtained by applying a unit load at the joint in
• A propped cantilever beam carrying total load “W” distributed evenly over its entire length calculate the vertical force required in the prop.