If in the above problem in Q5, if load P is excessively increased in simply supported beam, then where would a hinge like point form?

Related MCQs

• There are two beams of equal length L and a load P is acting on centre of both beams. One of them is simply supported at both ends while the other one is fixed at both ends. Deflection of centre of simply supported beam will be                      times that of defection of centre of fixed beam.
• A simply supported beam deflects by 5 mm when it is subjected to a concentrated load of 10 kN at its centre. What will be deflection in a 1/10 model of the beam if the model is subjected to a 1 kN load at its centre?
• When a series of wheel loads crosses a simply supported girder, the maximum bending moment under any given wheel load occurs when
• A fixed beam of the uniform section is carrying a point load at the centre, if the moment of inertia of the middle half portion is reduced to half its previous value, then the fixed end moments will              
• The maximum bending moment due to a train of wheel loads on a simply supported girder
• When a uniformly distributed load, longer than the span of the girder, moves from left to right, then the maximum bending moment at mid section of span occurs when the uniformly distributed load occupies
• If a beam has 4 external supports, then how many parts would it be divided in case of using slope deflection equations?
• The fixed support in a real beam becomes in the conjugate beam a
• Bending moment at any section in a conjugate beam gives in the actual beam
• If point A goes down and point B goes up, then this will be:-