during tensile test, type of loading should be avoided

Related MCQs

• tensile test was conducted on a steel specimen of diameter 20 mm and gauge length 75 mm. the gauge length and diameter during fracture are 95 mm and 12 mm respectively. If ultimate tensile load is 8000 kg, the UTS is                     
•                      shows good behavious under tensile type of loading
•                      are not used under tensile type loading
• during design and fabrication of the pipe and tanks, sharp bends and corners should be avoided because they form                    
• for measuring the elongation of specimen on UTM during tensile test is used
• during the tensile test, the length of specimen and its cross section area
• in tensile test, during strain hardening material after cold working shows                      in strength with decreased toughness
• during tensile test, if gauge length                   percentage elongation increases due to localised elongation
• tensile test was conducted on a steel specimen of diameter 20 mm and gauge length 75 mm. the gauge length and diameter during fracture are 95 mm and 12 mm respectively. Its elongation is
• tensile test was conducted on a steel specimen of diameter 20 mm and gauge length 75 mm. the gauge length and diameter during fracture are 95 mm and 12 mm respectively. If load at upper yield point is 500 kg, the upper yield stress is