A thrust bearing having collars of external and internal diameter as 40 cm and 20 cm respectively, carries an axial load of 3000 N. The co-efficient of friction is 0.09 and shaft runs at 420 rpm. The power lost in friction would be equal to ____.

Related MCQs

• A thrust bearing having collars of external and internal diameter as 40 cm and 20 cm respectively, carries an axial load of 3000 N. The co-efficient of friction is 0.09 and shaft runs at 420 rpm. The power lost in friction is to be determined. The corresponding value of friction torque would be ____.
• Following are the details pertaining to thrust bearing 1) External and internal dia of contacting surfaces-320 mm and 200 mm resp. 2) Axial load-80 kN 3)Pr. Intensity-350 kN/m2 4) shaft speed-400 rpm 5)coefficient of friction-0.06 Calculate power lost in overcoming friction. the frictional torque and power lost in frictional
• A flat foot step bearing 20 cm in diameter supports a load of 2500 kgf. The shaft is running at 420 rpm and the co-efficient is 0.09. The power lost in overcoming friction at the bearing, will be equal to ___.
• A conical pivot supports a load of 20 kN, and its semicone angle is 41.81 degree. The friction coefficient is 0.06 and shaft runs at 200 rpm. The torque required to overcome friction and power lost in friction is
• flat foot step bearing 20 cm in diameter supports a load of 2500 kgf. The shaft is running at 420 rpm and the co-efficient is 0.09. The power transmitted by the friction between the surface, will be equal to ___.
• A flat foot step bearing 225 mm in diameter supports a load of 7500 N. If the co-efficient of friction is 0.09 and the shaft rotates at 60 rpm, calculate the power lost in frictional torque and frictional power in watts with uniform pressure is ___.
• A flat foot step bearing 20 cm in diameter supports a load of 2500 kgf. The shaft is running at 420 rpm and the co-efficient is 0.09. The frictional torque, for uniform pressure, will be equal to ___.
• A flat foot step bearing 20 cm in diameter supports a load of 2500 kgf. The shaft is running at 420 rpm and the co-efficient is 0.09. The frictional torque, for uniform wear, will be equal to ___.
• In a multi-collared thrust bearing consisting of 'n' collars and subjected to axial load W, load sheared by each collar is _______.
• When the axial load carried by the shaft in case of flat collar bearing, is large; a number of collars are provided on the shaft. This is done____.