If the member shown in Fig. 1.1 has a
square cross section of 25 mm 25 mm and E = 200 GPa, the change in length of portion CD is ------mm

Related MCQs

• The axially loaded composite rod shown in Fig. 1.2 has a uniform cross- sectional area of 500 mm 2 . The modulii of elasticity are Est = 200 GPa, Eal = 70 GPa and Ecu = 120 GPa. The change in length of CD is mm.
• The axially loaded composite rod shown in Fig. 1.2 has a uniform cross- sectional area of 500 mm 2 . The modulii of elasticity are Est = 200 GPa, Eal = 70 GPa and Ecu = 120 GPa. The change in length of the composite rod is mm.
• If the member shown in Fig. 1.1 has a square cross section of 25 mm 25 mm and E = 200 GPa, the change in length of portion AB is              mm.
• A stepped bar of steel consists of a pmormtion with cross section area 500 mm2 connected to a portion with cross section area 1000 2. Each portion has a length of 1 m. The modulus of elasticity of steel is 200 GPa. The maximum elongation of the bar by applying an axial tensile force at the ends without exceeding a stress of 100 MPa is    mm.
• A strip of steel (E = 200 GPa, 0.25) has a length of 1 m, width of 200 mm and thickness of 10 mm. A line of length 1 m is drawn parallel to its length on one of its side surfaces. When the strip is subjected to an axial tensile force of 100 kN, the length of the line will be                  mm.
• A steel bar ABC (E = 200 GPa) is 1 m long. For AB = 0.7 m, it has cross section P area of 500 mm2 and for BC = 0.3 m the cross section area is 400 mm2. The bar is subjected to an axial pull of 100 kN. The stress is maximum in ___ _
• The change in length of a rod of uniform cross section was found to be 2 mm for some applied force. The change in length of a rod of the same material and length but of twice the cross section area subjected to the same force will be__ mm.
• If an axial force of 1 kN is applied to a rod of 100 mm2 cross section area, length 5 m and the modulus of elasticity of the material is 100 GPa, the change in length of the rod will be ___ .
• Two beams, one of circular cross-section and other of square cross-section, have equal areas of cross-section. If subjected to bending
• If an axial force of 15 kN is applied to a rod of 25 mm diameter, length 300 mm, the change in length of the rod was observed to be 0.045 mm. The modulus of elasticity of the material is 200 GPa. The strain in the rod will be ____ _.