The ultimate tensile stress for mild steel is

Related MCQs

• A mild steel flat 3 m long 150 mm wide and 15 mm thick carries an axial tensile load of 150 kN. If the value of u for mild steel is 0.3, it can be concluded that
• At a point in a steel member, the major principal stress is 2000 kg/cm2 and the minor principal stress is compressive. If the uni-axial tensile yield stress is 2500 kg/cm2, then the magnitude of the minor principal stress at which yielding will commence, according to the maximum shearing stress theory, is
• A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa on a plane at right angles to the former. It is also subjected to a shear stress of 400 MPa on the same planes. The maximum normal stress will be
• When a body is subjected to a direct tensile stress (?), maximum normal stress is equal to the direct tensile stress.
• The force required to punch a 25 mm hole in a mild steel pipe 10 mm thich, when ultimate shear stress of the plate is 500 N/mm2 will be nearly
• Force required to punch a 15 mm hole in a mild steel pipe 5 mm thick, when ultimate shear stress of the plate is 500 N/mm2, will be nearly
• In a thick cylindrical shell subjected to an internal pressure (p), the tangential stress is always a tensile stress where as the radial stress is a compressive stress
• The ratio of ultimate tensile stress to the design stress is known as
• A stepped bar of steel consists of a pmormtion with cross section area 500 mm2 connected to a portion with cross section area 1000 2. Each portion has a length of 1 m. The modulus of elasticity of steel is 200 GPa. The maximum elongation of the bar by applying an axial tensile force at the ends without exceeding a stress of 100 MPa is    mm.
• A steel wire is hang vertically under its own weight. What is the greatest length it can have if the allowable tensile stress is 2000 kg/cm2 and specific weight of steel is 8000 kg/cm