A tensile test is performed on a mild steel round bar. Its diameter after fracture will

Related MCQs

• A tensile test is performed on a round bar. After fracture it has been found that the diameter remains approximately same at fracture. The material under test was
• A mild steel flat 3 m long 150 mm wide and 15 mm thick carries an axial tensile load of 150 kN. If the value of u for mild steel is 0.3, it can be concluded that
• A stepped bar of steel consists of a pmormtion with cross section area 500 mm2 connected to a portion with cross section area 1000 2. Each portion has a length of 1 m. The modulus of elasticity of steel is 200 GPa. The maximum elongation of the bar by applying an axial tensile force at the ends without exceeding a stress of 100 MPa is    mm.
• A mild steel bolt of net cross-sectional area 8.4 sq. cm, diameter 37 will be safe to take a tensile load of about
• Two shafts are made of mild steel one having circular cross-section and the other shaft is hollow circular with inner diameter half of the outer diameter. The ratio of the torque that can be transmitted in two cases will be
• A steel bar 2 m long, 20 mm wide and 10 mm thick is subjected to a pull of 2 kN. If the same bar is subjected to a push of 2 kN, the Poission's ratio of the bar in tension will be
• The ultimate tensile stress for mild steel is
• A prismatic bar of volume V is subjected to a tensile force in longitudinal direction. If Poisson's ratio of the material is u and longitudinal strain is e, then the final volume of the bar becomes
• A bar of length L metres extends by l mm under a tensile force of P. The strain produced in the bar is
• A steel wire is hang vertically under its own weight. What is the greatest length it can have if the allowable tensile stress is 2000 kg/cm2 and specific weight of steel is 8000 kg/cm