A bar of length L metres extends by l mm under a tensile force of P. The strain produced in the bar is

Related MCQs

• A strip of steel (E = 200 GPa, 0.25) has a length of 1 m, width of 200 mm and thickness of 10 mm. A line of length 1 m is drawn parallel to its length on one of its side surfaces. When the strip is subjected to an axial tensile force of 100 kN, the length of the line will be                  mm.
• A prismatic bar of volume V is subjected to a tensile force in longitudinal direction. If Poisson's ratio of the material is u and longitudinal strain is e, then the final volume of the bar becomes
• A uniform steel rope 400 metres long is hung vertically. The weight of the steel is 7.8 gm/cm3 and D = 2100 kg/mm2. The ratio of elongation of first 150 metres to that of first 300 metres would be
• If a bar of length L m extends by l mm under load W, the strain is
• A stepped bar of steel consists of a pmormtion with cross section area 500 mm2 connected to a portion with cross section area 1000 2. Each portion has a length of 1 m. The modulus of elasticity of steel is 200 GPa. The maximum elongation of the bar by applying an axial tensile force at the ends without exceeding a stress of 100 MPa is    mm.
• A bar of 30 mm diameter is subjected to an axial force 280 KN length of bar is 400 m and E= 200GPa. Determine volumetric strain if m=4.
• The tensile force at a distance y from support in a vertical hanging bar of length L whch carries a load P at the bottom is equal to---- where w = weight per unit length
• Under uniaxial strain, the ratio of maximum shearing strain to uniaxial strain is
• In a tensile test, when the material is stressed beyond elastic limit, the tensile strain
• The change in length of a rod of uniform circular cross section was found to be 2 mm for some applied force. The change in length of a rod of the same material and length but of half the diameter subjected to the same force will be Mm