A mild steel bolt of net cross-sectional area 8.4 sq. cm, diameter 37 will be safe to take a tensile load of about

Related MCQs

• A mild steel flat 3 m long 150 mm wide and 15 mm thick carries an axial tensile load of 150 kN. If the value of u for mild steel is 0.3, it can be concluded that
• A bolt of nominal diameter 33 mm having a safe tensile stress of 100 N/mm2 can safely carry a load of
• A tensile test is performed on a mild steel round bar. Its diameter after fracture will
• A stepped bar of steel consists of a pmormtion with cross section area 500 mm2 connected to a portion with cross section area 1000 2. Each portion has a length of 1 m. The modulus of elasticity of steel is 200 GPa. The maximum elongation of the bar by applying an axial tensile force at the ends without exceeding a stress of 100 MPa is    mm.
• Two shafts are made of mild steel one having circular cross-section and the other shaft is hollow circular with inner diameter half of the outer diameter. The ratio of the torque that can be transmitted in two cases will be
• The ultimate tensile stress for mild steel is
• The safe working pressure for a spherical vessel 1.5 m diameter and 1.5 cm wall thickness with limiting tensile stress of 450 kg/cm2 would be
• Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be
• If a prismatic member with area of cross-section A is subjected to a tensile load P, then the maximum shear stress and its inclination with the direction of load respectively are
• In a universal testing machine during the testing of a specimen of original cross-sectional area 1 cm2 the maximum load appliied was 7.5 tonnes and neck area 0.6 sq. cm. The ultimate tensile strength of the specimen is