[Solved] Totem-pole outputs be connected because .

McqMate

Q.	Totem-pole outputs be connected because .
A.	can, in parallel, sometimes higher current is required
B.	cannot, together, if the outputs are in opposite states excessively high currents can damage one or both devices
C.	should, in series, certain applications may require higher output voltage
D.	can, together, together they can handle larger load currents and higher output voltages
Answer» B. cannot, together, if the outputs are in opposite states excessively high currents can damage one or both devices

2k

0

Do you find this helpful?

17

View all MCQs in

Digital Electronics and Logic Design

Discussion

No comments yet

Related MCQs

THE FOUR OUTPUTS OF TWO 4-INPUT MULTIPLEXERS, CONNECTED TO FORM A 16-INPUT MULTIPLEXER, ARE CONNECTED TOGETHER THROUGH A 4-INPUT GATE
Which of the following logic gives the complementary outputs?
For the device shown here, assume the D input is LOW, both S inputs are HIGH, and the input is HIGH. What is the status of the outputs?
A certain BCD-to-decimal decoder has active-HIGH inputs and active- LOW outputs. Which output goes LOW when the inputs are 1001?
How many outputs would two 8-line-to-3-line encoders, expanded to a 16-line-to-4-line encoder, have?
The input at the 1, 2, 4, 8 inputs to a 4-line to 16-line decoder with active- low outputs is 1110. As a result, output line 7 is driven LOW.
3: Flip-flop outputs are always
A sequential circuit outputs a ONE when an even number (> 0) of one's are input; otherwise the output is ZERO. The minimum number of states required is
In outputs depend only on the current state.
In outputs depend only on the combination of current state and inputs