A grinding wheel rotates at 3000 rpm. When power supply is cut off the wheel stops in 5 sec. The number of revolutions made by the wheel before coming to rest would be

Related MCQs

• A grinding wheel rotates at 3000 rpm. When power supply is cut-off the wheel stops in 10 seconds. The number of revolutions made by the wheel before coming to rest would be
• A grinding wheel is rotating at 3000 rpm. When the switch is turned off the wheel stops in 10 seconds. The uniform deceleration of the wheel was
• The number of revolutions through which a pulley will rotate from rest if its angular acceleration is increased uniformly from zero to 12 rad per sec2 during 4 sec and then uniformly decreased to 0 rad per sec2 during the next 3 sec would be
• A flywheel starting from rest and accelerating uniformly performs 25 revolutions in 5 sec. Its angular velocity in rpm after 10 seconds would be
• A wheel accelerates from rest with an acceleration of 6 rad/sec2. How many revolutions are experienced in 4 seconds?
• What is the total acceleration of a point on the rim of a flywheel 4 mts in diameter 0.6 see after it has started from rest if it accelarates uniformly from rest to 2000 rpm in 20 secs.
• The torque of 50 Nm is applied on the wheel operating a valve. If the wheel is rotated through two revolutions, work done in Newton-metres is given by
• A wheel 8 mts in diameter coasts to rest from a speed of 800 rpm in 10 minutes. Its angular deceleration is
• A cannon of weight 10 tonnes fires a shell of 50 kg with a muzzle velocity of 900 m/sec at an angle of 30?. The time taken for the shell to emerge from the barrel is 0.004 sec. The velocity of the cannon would be
• In a single threaded worm and worm wheel the number of teeth on the worm wheel is 80. The diameter of the effort wheel is 12 cm and that of load drum is 8 cm. The velocity ratio will be