The flow of water in a pipe of diameter 3000 mm can be measured by

Related MCQs

• At point A in a pipe line carrying water the diameter is 1 m, the pressure 98 kPa and the velocity 1 m/s. At point B, 2 m higher than A, the diameter is 0.5 m and the pressure 20 kPa. The direction of flow would be
• The velocity in a 2 cm-diameter pipe is 20 m/s. If the pipe enlarges to 5 cm diameter velocity, in m/s, will be
• The distance from pipe boundary, at which the point velocity is equal to average velocity in case of turbulent flow (when R is the radius of the pipe), is
• Flow in a pipe where average flow parameters are considered for analysis is an example of
• 2𝑔 148. The power transmitted through the pipe is maximum when head lost due to friction in the pipe is equal to
• A U-tube manometer, attached to an air pipe, measures 20 cm of mercury. The pressure, in kPa, in the air pipe is
• A turbine model test with 260 mm diameter showed an efficiency of 90 percent. The efficiency that can be expected from a 1.2 m diameter impeller is
• The head loss in a pipe flow can be calculated using
• A mercury water manometer indicates a gauge difference of 400 mm. The difference in pressure, measured in metres of water, is
• In case of turbulent flow of a fluid through a circular tube (as compared to the case of laminar flow at the same flow rate) the maximum velocity is ....., shear stress at the wall is ....., and the pressure drop across a given length is ....., the correct words for the blanks are, respectively