Which of the following facilitates shaking and lifting large pattern from the mould?

Related MCQs

• The moulding tool used for finishing/repairing the sand mould after pattern withdrawal is termed as
• There is no need for the withdrawal of pattern from the mould in case of
• Rammer used for moulding the sand in large mould known as
• Normal shrinkage allowance for aluminium is 18 mm per metre and that for cast iron 10 mm per metre. If the metal pattern is to be made of aluminium and the casting is to be of cast iron, the shrinkage allowed on wooden master pattern will be
• Which of the following is used on moulds for magnesium castings to prevent metal mould reactions?
• A mould which has good erosion resistance to metal flow and is also collapsible is
• The hardness of the mould is affected by the proportion of ingredients in the sand and
• If dross and slag along with the liquid metal reach the mould cavity they produce the defect known as
• The defect known as 'drop' occurs when the upper surface of the mould cracks and pieces of sand fall into the molten metal. This defect occurs due to
• A defect in castings in which a discontinuity is formed due to the imperfect fusion of two streams of metal in the mould cavity is known as