A section is subjected to reversal of stresses. Choice exists for selecting any of the following section. Which one should be selected?

Related MCQs

• In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mild steel occurs on a plane inclined at
• Full stress reversal normally does not occur in bolted connections due to
• If screw threads are to be used in a situation involving high stresses in one direction only, the types of threads suitable for this would be
• A cantilever beam of square section is subjected to a load W at the free end. If the length of the beam is increased and load reduced to half the deflection at the free end as compared to original deflection would be
• The minor-diameter cross-section of the portion of the screw between the nut and the thrust bearing is subjected to
• When the bolt is subjected to shock loading the resilience of the bolt should be considered in order to prevent breakege at
• The pin supporting the exhaust iever of an internal combustion engine is subjected to a shear load of 400 kg/sq-cm the diameter of the pin should be
• Resilience of material should be considered when it is subjected to
• If machine number is loaded in such a way that the three principla stresses at a point are 600 kg/cm2 compression. 800 kg/cm2 tension and zero. The maximum shear stress at the point will be
• If a machine member is loaded in such a way that the three principal stresses at a point are 600 kg/cm2 tension, 800 kg/cm2 compression and zero. The maximum shear stress at the point will be