If machine number is loaded in such a way that the three principla stresses at a point are 600 kg/cm2 compression. 800 kg/cm2 tension and zero. The maximum shear stress at the point will be

Related MCQs

• If a machine member is loaded in such a way that the three principal stresses at a point are 600 kg/cm2 tension, 800 kg/cm2 compression and zero. The maximum shear stress at the point will be
• In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be
• In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mild steel occurs on a plane inclined at
• The ratio of maximum shear stress to average shear stress for a circular section is
• For maximum horse power transmission in belt drives the velocity of belt left such that the ration tight side driving tension/centrifugal tension is
• For determination of allowable stress in axial compression, IS : 800-1962 has adopted
• Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be
• With a punch for which the maximum crushing stress is 4 times the maximum shearing stress of the plate, the biggest hole that can be punched in the plate would be of diameter equal to
• According to IS 800, the lacing bars should resist a transverse shear equal to
• Which of the following theory is also known as maximum shear stress theory of the failure of a material at the elastic limit