While designing for screw threads care should be taken to provide adequate length of engagement for the screw and nut threads so as to prevent failure of threads in

Related MCQs

• If the shearing stress in a nut is equal to half the tensile stress in a bolt then the length of nut should be equal to
• If the threads on a bolt are right hand the threads on nut will be
• While designing a shaft, hub and a key, care is taken so that
• If screw threads are to be used in a situation involving high stresses in one direction only, the types of threads suitable for this would be
• The minor-diameter cross-section of the portion of the screw between the nut and the thrust bearing is subjected to
• The pitch of threads on a lock-nut is
• While designing a warm and a worm wheel the sign should be governed by
• While designing a shaft pulley and key for a system
• The clamping nut of the turn buckle has
• When a nut is tightened by placing a washer below it, the bolt will be subjected to