While designing a shaft, hub and a key, care is taken so that

Related MCQs

• A key and a shaft are made from the same material. The key is rectangular with a width of D/4 and a height of 3D/16. The shaft is under torsion only. The necessary length of the key for equal strength of the shaft and key will be
• A solid shaft and a hollow shaft are to be of equal strength in torsion. The hollow shaft is to be 10% larger in diameter than the solid shaft. The ratio of the weight of the hollow shaft will be (both shafts being made of same material)
• While designing for screw threads care should be taken to provide adequate length of engagement for the screw and nut threads so as to prevent failure of threads in
• While designing a shaft pulley and key for a system
• If a square key and the shaft are to be of the same material and of equal strength, the length of key would be (d = dia. Of shaft)
• Which of the following key permits axial relative motion between the shaft and the hub?
• A solid shaft of 100 mm diameter transmits 100 HP at (450/?) r.p.m. The torque in kg-m on the shaft would be
• While designing a warm and a worm wheel the sign should be governed by
• A shaft subjected to combined bending and torsion can be designed by the following stress theory
• The critical speed of a shaft is affected by