If the shearing stress in a nut is equal to half the tensile stress in a bolt then the length of nut should be equal to

Related MCQs

• A foundation bolt with a circular end is secured to the floor by means of a steel cotter. If the pull on the bolt is 14000 kg, the diameter of the bolt should be
• When the bolt is subjected to shock loading the resilience of the bolt should be considered in order to prevent breakege at
• A motor weighing 2000 kg is to be lifted by wrought iron eye bolt, screwed into the frame. Clioose-single bolt out of the following
• When a nut is tightened by placing a washer below it, the bolt will be subjected to
• When a nut is tightened by placing a washer under it, the bolt tends to fall in
• If the threads on a bolt are right hand the threads on nut will be
• With a punch for which the maximum crushing stress is 4 times the maximum shearing stress of the plate, the biggest hole that can be punched in the plate would be of diameter equal to
• In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be
• While designing for screw threads care should be taken to provide adequate length of engagement for the screw and nut threads so as to prevent failure of threads in
• Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be