A portion of a beam between two sections is said to be in pure bending when there is

Related MCQs

• A portion of a beam between two sections is said to be in pure bending when there is
• In a simple bending theory, one of the assumption is that the plane sections before bending remain plane after bending. This assumption means that.
• In the simple bending theory one of the assumptions usually made is that the plane sections before bending remain plane after bending. This assumption implies that
• The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called
• The bending moment diagram for a cantilever beam subjected to bending moment at the end of the beam would be
• A section of beam is said to be in pure bending, if it is subjected to
• The ratio of the area under the bending moment diagram between any two points along a beam to the flexural rigidity EI gives the change to the following parameter between the two points
• When there is no increase or decrease in shear force between two points, it indicates that there is no change in the bending moment between these points.
• A beam of overall length 1 with equal overhangs on both sides carries a uniformly distributed load over the entire length. To have numerically equal bending moments at centre of the beam and at supports, the distance between the supports should be
• In a beam subjected to pure bending, the intensity of stress in any fibre is