The torsional resisting moment of the following section is being considered with identical characteristic parameter. Which section will have maximum torsional resisting moment

Related MCQs

• When a body is subjected to two equal and opposite forces, acting tangentially across the resisting section, as a result of which the body tends to shear off across the section, the stress and strain induced is
• A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to
• The plastic moment of a beam can be 50 percent more than the maximum elastic moment in case the cross-section of the beam is
• The ratio of the area under the bending moment diagram between any two points along a beam to the flexural rigidity EI gives the change to the following parameter between the two points
• A simply supported beam of length 1 carries a load varying uniformly from zero at left end to maximum at right end. The maximum bending moment occurs at a distance of
• A rectangular beam 200 mm deep by 100 mm wide-subjected to maximum bending moment of 500 kNm. The maximum stress in the beam will be
• A beam of rectangular cross-section is 100 mm wide and 200 mm deep. If the section is subjected to a shear force of 20 kN, then the maximum shear stress in the section is
• The bending moment on a section is maximum where shear force is
• Two beams, one of circular cross-section and other of square cross-section, have equal areas of cross-section. If subjected to bending
• If shear force is zero along a section, the bending moment at that section will be