Moment area method is useful determining the following in a beam

Related MCQs

• The plastic moment of a beam can be 50 percent more than the maximum elastic moment in case the cross-section of the beam is
• The bending moment diagram for a cantilever beam subjected to bending moment at the end of the beam would be
• A prismatic beam fixed at both ends carries a uniformly distributed load. The ratio of bending moment at the supports to the bending moment at mid-span is
• The maximum bending moment for a simply supported beam with a gradually varying load from zero at both ends and w per metre at the centre, lies at the centre of a beam.
• A beam supporting a uniformly distributed load over its entire length L is pinned at one end and passes over a roller support at a distance x from the other end. The value of x such that the greatest bending moment in the beam is as small as possible, will be
• A rectangular beam 200 mm deep by 100 mm wide-subjected to maximum bending moment of 500 kNm. The maximum stress in the beam will be
• The ratio of the area under the bending moment diagram between any two points along a beam to the flexural rigidity EI gives the change to the following parameter between the two points
• A cantilever beam carries a uniformly distributed load from fixed end to the centre of the beam in the first case and a uniformly distributed load of same inten¬sity from centre of the beam to the free end in the second case. The ratio of deflections in the two cases is
• A simply supported beam with rectangular cross-section is subjected to a central concentrated load. If the width and depth of the beam are doubled, then the deflection at the centre of the beam will be reduced to
• The rectrangular beam 'A' has length l, width b and depth d. Another beam 'B' has the same length and depth but width is double that of 'A'. The elastic strength of beam B will be