The light gauge steel structural members are usually

Related MCQs

• A hole, one metre from the end of a structural steel member, is 0.8 mm shy of matching another hole for possible connection. What force, in kN, is necessary to stretch it for connection? The cross section is 25 mm x 3 mm
• The maximum strains at the end of plastic range of structural steel is about
• If ES = 3 EA , the stress in steel of a composite bar made of aluminium and steel strips each having a cross sectional area of 300 mm2 and subjected to an axial load of 12 kN
• A stepped bar of steel consists of a pmormtion with cross section area 500 mm2 connected to a portion with cross section area 1000 2. Each portion has a length of 1 m. The modulus of elasticity of steel is 200 GPa. The maximum elongation of the bar by applying an axial tensile force at the ends without exceeding a stress of 100 MPa is    mm.
• A steel strip is welded to a copper strip of the same dimensions along the length. The coefficient of thermal expansion for copper is greater than that for steel. If temperature is increased, ___ .
• A flitched beam consists of a wooden joist 150 mm wide and 300 mm deep strengthened by steel plates 10 mm thick and 300 mm deep one on either side of the joist. If modulus of elasticity of steel is 20 times that of wood, then the width of equivalent wooden section will be
• A steel wire is hang vertically under its own weight. What is the greatest length it can have if the allowable tensile stress is 2000 kg/cm2 and specific weight of steel is 8000 kg/cm
• A brittle steel rod is heated to 160?C and then suddenly clamped at both ends. It is then allowed to cool and breaks at a temperature of 85?C. If E = 200 GN/m2 and ? = 12 x 10-5 / ?C, the breaking stress of steel is
• A prismatic steel bar 25 cm long is subjected to axial compressive force of 2000 kg. For steel E = 2 x 106 kg/cm2. The ratio of strain energy when the cross-sectional area is 25 sq. cm to that when the cross-section area is 12.5 sq cm, would be
• A mild steel flat 3 m long 150 mm wide and 15 mm thick carries an axial tensile load of 150 kN. If the value of u for mild steel is 0.3, it can be concluded that