It is desired to punch a hole of 20 mm diameter in a plate 20 mm think. If the shear stress of mild steel is 30 kg/mm2, the force necessary for punching would be approximately in the range

Related MCQs

• For punching a hole of 25 mm diameter in a plate 20 mm thick, if the shear stress of plate material is 30 kg/mm2, the force required would be
• The force required to punch a 25 mm hole in a mild steel pipe 10 mm thich, when ultimate shear stress of the plate is 500 N/mm2 will be nearly
• Force required to punch a 15 mm hole in a mild steel pipe 5 mm thick, when ultimate shear stress of the plate is 500 N/mm2, will be nearly
• With a punch for which the maximum crushing stress is 4 times the maximum shearing stress of the plate, the biggest hole that can be punched in the plate would be of diameter equal to
• While punching a hole in a metal sheet using a punch, stress is developed in the Punch.
• A sheet metal 2 mm thick having a shear strength of 40 kg/cm2 is to receive a punch hole of 35 mm diameter. The force required to make the punching will be
• While punching a hole in a metal sheet using a punch, stress is developed in the metal sheet.
• A hole, one metre from the end of a structural steel member, is 0.8 mm shy of matching another hole for possible connection. What force, in kN, is necessary to stretch it for connection? The cross section is 25 mm x 3 mm
• Two steel shaft each of length L and outside diameter D are subjected to uniform torsion. The first shaft is solid while the second one is hollow with inside diameter D/2. The ratio of the strain energies that these two shafts can absorb without exceeding a maximum allowable shear stress, would be
• A mild steel flat 3 m long 150 mm wide and 15 mm thick carries an axial tensile load of 150 kN. If the value of u for mild steel is 0.3, it can be concluded that