[Solved] A mouthpiece is a short length of a pipe which is not more than times its diameter.

Q.	A mouthpiece is a short length of a pipe which is not more than times its diameter.
A.	3-4
B.	5-6
C.	1 -2
D.	2-3
Answer» D. 2-3
Explanation: a mouth piece is defined as a short length of a pipe which is not more than two or three times its diameter, fitted to an orifice of same diameter provided especially in a tank containing liquid.

4.4k

Do you find this helpful?

View all MCQs in

Structural Analysis 1

Discussion

No comments yet

Related MCQs

Study the following statements. (i) The displacement method is more useful when degree of kinematic indeterminacy is greater than the degree of static indeterminacy. (ii) The displacement method is more useful when degree of kinematic indeterminacy is less than the degree of static indeterminacy. (iii) The force method is more useful when degree of static indeterminacy is greater than the degree of kinematic indeterminacy. (iv) The force method is more useful when degree of static indeterminacy is less than the degree of kinematic indeterminacy. The correct answer is
There are two beams of equal length L and a load P is acting on centre of both beams. One of them is simply supported at both ends while the other one is fixed at both ends. Deflection of centre of simply supported beam will be times that of defection of centre of fixed beam.
A propped cantilever beam carrying total load “W” distributed evenly over its entire length calculate the vertical force required in the prop.
All reinforced concrete buildings are most of times:-
A simply supported beam deflects by 5 mm when it is subjected to a concentrated load of 10 kN at its centre. What will be deflection in a 1/10 model of the beam if the model is subjected to a 1 kN load at its centre?
in most cases, for a given loading maximum stress and deflection of an indeterminate structure are than that of a determinate one.
When a uniformly distributed load, longer than the span of the girder, moves from left to right, then the maximum bending moment at mid section of span occurs when the uniformly distributed load occupies
When a uniformly distributed load, shorter than the span of the girder, moves from left to right,then the conditions for maximum bending moment at a section is that
A fixed beam of the uniform section is carrying a point load at the centre, if the moment of inertia of the middle half portion is reduced to half its previous value, then the fixed end moments will
Which of the following is not a hydraulic coefficient?