A system is said to be                           if it is possible to transfer the system state from any initial state to any desired state in finite interval of time.

Related MCQs

• A system is said to be                                    if every state can be completely identified by measurements of the outputs at the finite time interval.
• System transformation on function H(z) for a discrete time LTI system expressed in state variable form with zero initial condition
• Determine the sensitivity of the overall transfer function for the system shown in the figure below, at w=1 rad/sec with respect to the feedback path transfer function.
• A transfer function has two zeroes at infinity. Then the relation between the numerator(N) and the denominator degree(M) of the transfer function is:
• From the following graphs of the generalized transfer function 1/s+a, which plot shows a transfer function with a bigger value of a?
• From the following graphs of the generalized transfer function 1/as2, which plot shows the transfer function for a higher a?
• A linear system at rest is subject to an input signal r(t)=1-e-t. The response of the system for t>0 is given by c(t)=1-e-2t. The transfer function of the system is:
• The step response of the system is c(t) = 10+8e-t-4/8e-2t . The gain in time constant form of transfer function will be:
• A particular control system yielded a steady state error of 0.20 for unit step input. A unit integrator is cascaded to this system and unit ramp input is applied to this modified system. What is the value of steady- state error for this modified system?
• The roots of the transfer function do not have any effect on the stability of the system.