McqMate

Q. |
## For a self-bias circuit, find drain to source voltage if VDD=12V, ID=1mA, Rs=RD=1KΩ? |

A. | 1v |

B. | 2v |

C. | 10v |

D. | 5v |

Answer» C. 10v | |

Explanation: vds=vdd-id (rd+rs) |

3.6k

0

Do you find this helpful?

31

View all MCQs in

Electronic Circuits 1No comments yet

- If source resistance in an amplifier circuit is zero, then voltage gain (output to input voltage ratio) and source voltage gain (output to source voltage ratio) are the same.
- For a fixed bias circuit the drain current was 1mA, VDD=12V, determine drain resistance required if VDS=10V?
- If peak voltage for a half wave rectifier circuit is 5V and diode cut in voltage is 0.7, then peak inverse voltage on diode will be?
- If the peak voltage on a centre tapped full wave rectifier circuit is 5V and diode cut in voltage is 0.7. The peak inverse voltage on diode is
- Which of the following equation brings the relation between gate to source voltage and drain current in Self Bias?
- For a fixed bias circuit the drain current was 1mA, what is the value of source current?
- Consider the following circuit. Process transconductance parameter = 0.50 mA/V2, W/L=1, Threshold voltage = 3V, VDD = 20V. Find the operating point of circuit.
- Find the gate to source voltage for voltage divider having R1=R2=2KΩ and VDD=12V, ID=1mA and RS=4KΩ?
- Consider the following circuit, where source current = 10mA, hfe = 50, hie = 1100Ω, then for the transistor circuit, find output resistance RO and input resistance RI.
- Process transconductance parameter is 40μA/V2. Find drain to source current in saturation.