McqMate

Q. |
## Process transconductance parameter is 40μA/V2. Find drain to source current in saturation. |

A. | 0.10 ma |

B. | 0.05ma |

C. | – 0.05ma |

D. | – 50a |

Answer» C. – 0.05ma | |

Explanation: isd = k’w(vsg – |

1.4k

0

Do you find this helpful?

1

View all MCQs in

Electronic Circuits 1No comments yet

- Consider the following circuit. Process transconductance parameter = 0.50 mA/V2, W/L=1, Threshold voltage = 3V, VDD = 20V. Find the operating point of circuit.
- For a fixed bias circuit the drain current was 1mA, VDD=12V, determine drain resistance required if VDS=10V?
- In the given situation for n-channel JFET, we get drain-to-source current is 5mA. What is the current when VGS = – 6V?
- For a fixed bias circuit the drain current was 1mA, what is the value of source current?
- For a self-bias circuit, find drain to source voltage if VDD=12V, ID=1mA, Rs=RD=1KΩ?
- Which of the following equation brings the relation between gate to source voltage and drain current in Self Bias?
- The transconductance of a B.J.T.is 5mS (gm) while a 2KΩ (Rl) load resistance is connected to the C.E. stage. Neglecting Early effect, what is the Miller multiplication factor for the input side?
- 1, α2 = 1.5 what is the transconductance of the entire network?
- If the transconductance of the B.J.T increases, the transit frequency
- If a C.E. stage has a load Rl and transconductance gm, what is the factor by which the capacitance between the base and the collector at the input side gets multiplied?