- Civil Engineering
- Engineering Graphics
- Cone- base parallel to V.P iv. Tria...

Q. |
## Cone- base parallel to V.P iv. Triangle |

A. | 1, i; 2, ii; 3, iii; 4, iv |

B. | 1, iv; 2, iii; 3, ii; 4, i |

C. | 1, ii; 2, iv; 3, iii; 4, i |

D. | 1, iii; 2, i; 3, iv; 4, ii |

Answer» D. 1, iii; 2, i; 3, iv; 4, ii | |

Explanation: if base of solid is parallel to one of the reference planes then its axis perpendicular to that plane and vice versa. cone is formed by revolving triangle about |

View all MCQs in:
Engineering Graphics

- A regular cone is resting on H.P on its base. A section plane is perpendicular to H.P and V.P cutting the cone such that the plane is not having axis of cone in it. The section would be
- A regular cone is resting on V.P with axis perpendicular to it a plane is cutting the cone such that it is perpendicular to H.P and inclined to V.P cutting cone at all generators the section formed is
- An equilateral triangle of side 10 cm is held parallel to horizontal plane and base is parallel to xy reference line. The length of line from front view will be
- An equilateral triangle of side 10 cm is held parallel to horizontal plane and base is parallel to xy reference line. The length of line from side view will be
- The top view, front view and side view of a triangle parallel to vertical plane, circle parallel to profile plane and rectangle parallel to horizontal plane respectively are
- When the plane cuts the cone at angle parallel to the axis of the cone, then is formed.
- A regular cone is placed such that axis is parallel to both reference planes the section plane perpendicular to both reference planes and cuts the cone the section will be like
- A regular cone is placed on H.P and section plane is parallel to axis cutting the cone at the middle then the section will be
- A regular cone is been cut by a plane which is parallel to the axis of cone the section formed will be like
- A regular cone is been cut by a plane which is parallel to the axis of cone, the section formed will be like

Login to Continue

It will take less than 2 minutes

Report MCQ