According to IS: 800, in the Merchant Rankine formula the value of imperfection index (n) is

Related Questions

• According to IS : 800-1962 the permissible bending stress in steel slab plates, is
• According to IS: 800-1962, the coefficient of expansion of steel per degree centigrade per unit length, is taken as
• According to I.S. : 800 - 1871, lacing bars resist transverse shear equal to
• According to IS : 800 - 71, the minimum thickness of a vertically stiffened web plate, shall not be less than
• According to IS: 800-1962, the coefficient of expansion of steel per degree centigrade per unit length, is taken as
• Efficiency of a riveted joint, having the minimum pitch as per IS : 800, is
• IS : 800 - 1971 recommends that in a splice plate the number of rivets carrying calculated shear stress through a packing greater than 6 mm thick, is to be increased by 2.5% for every
• As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
• As per IS : 800, for compression flange, the outstand of flange plates should not exceed
• IS : 800 - 1971 recommends that in a splice plate the number of rivets carrying calculated shear stress through a packing greater than 6 mm thick, is to be increased by 2.5% for every