- Civil Engineering
- Design of Steel Structures
- The slenderness ratio of a column is zer...

Q. |
## The slenderness ratio of a column is zero when its length |

A. | is zero |

B. | is equal to its radius of gyration |

C. | is supported on all sides throughout its length |

D. | is between the points of zero moments |

Answer» D. is between the points of zero moments |

View all MCQs in:
Design of Steel Structures

- The slenderness ratio of a column supported throughout its length by a masonry wall is
- The slenderness ratio of a column supported throughout its length by a masonry wall is
- If the unsupported length of a stanchion is 4 metres and least radius of gyration of its cross-section is 5, the slenderness ratio of the stanchion, is
- If the unsupported length of a stanchion is 4 metres and least radius of gyration of its cross-section is 5, the slenderness ratio of the stanchion, is
- The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is
- The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is
- To keep the intensity of bearing pressure between the column base and concrete, compressive throughout the length of the column base, the ratio of the moment M to axial load P should be
- If the area of cross-section of a single angle discontinuous strut is 30 cm2 and allowable working stress corresponding to its slenderness ratio is 625 kg/cm2, the safe load carrying capacity of the member, is
- When the upper column does not provide full bearing area over lower column, the column splice is provided with the following assumption
- For a column of height fixed in position and direction both at its top and bottom, its effective length, is

Login to Continue

It will take less than 2 minutes

Report MCQ