[Solved] To design a cross-over between parallel tracks, the required components are:

McqMate

Q.	To design a cross-over between parallel tracks, the required components are:
A.	two switch points, two acute angle crossings and two check rails
B.	two switch points, two acute angle crossings and four check rails
C.	two switch points, two acute angle crossings and six check rails
D.	none of these
Answer» B. two switch points, two acute angle crossings and four check rails

2.2k

0

Do you find this helpful?

11

View all MCQs in

Railway Engineering

Discussion

No comments yet

Related MCQs

If D is the distance between parallel tracks G between theoretical noses of two crossings measured parallel to tracks, is
If D is distance between centres of two parallel tracks of gauge G with entire curved leads and equal angles of crossing, total length of crossover, is
Which of the following devices is used to transfer the wagons or locomotives to and from parallel tracks without any necessity of shunting?
Heel divergency, the distance between the running faces of stock rail and gauge face of tongue rail, as recommended for Indian B.G. tracks, is
Two cross-overs are laid between two tracks in the case of
According to Indian Railways Board, the minimum distance between the centre to centre of two tracks for broad gauge is
The grade compensation on B.G. tracks on Indian Railways, is
The type of switch generally used for B.G. and M.G. tracks, is
On B.G. tracks the distance of outer signal from station limit is kept
The lengths of the standard crossings in India for Broad gauge and Metre gauge tracks is same for