At the time of making a purchase agreement with a vendor, what is important to mention about inspection?

Related MCQs

• The inspection of the project through the implementation phase is critical to ensure that quality standards are being met. The use of vendors is most often required to obtain critical materials, components, or sub-assemblies. To determine a vendor's capabilities to produce to the specifications, a "shop survey" or audit of the vendor may be required. e areas for the audit should include ______________.
• The key to quality is to design and build to the requirements and avoid attempts to inspect quality into the product. There is a need, however, to conduct inspections a critical junctures in the assembly process to ensure defective items are identified prior to making a costly interface or concealing a physical attribute that cannot be inspected at a later time. Inspection plan will identify the points at which examinations of processes, materials, or assemblies are required. However, inspection plans normally do not include ______________.
• Self-inspection by the individual performing the work is used to achieve quality in a product. The advantages of self-inspection include ______________.
• An advertising executive is studying television-viewing habits of married men and women during prime time hours. On the basis of past viewing records, the executive has determined that during prime time, husbands are watching television 40% of the time. It has also been determined that when the husband is watching television, 40% of the time the wife is also watching. When the husband is not watching television, 30% of the time the wife is watching television. Find the probability that the wife is watching television in prime time.
• Inspection, scrap, and repair are examples of ______________
• Inspection is part of the ______________
• For a given sample size (n) and number of defects acceptable ©, the Average Total Inspection (of units) should ______________ with increase in N (lot size).
• Average Total Inspection is defined as:
• Let p0 be the incoming fraction defective and p1 be the outgoing fraction defective (Assume both p1 and p0 is greater than 0). If rectifying inspection is performed then:
• Inspection of incoming/outgoing items is an example of ______________.