Choose the most important factor on which the heat conducted through a wall in a unit time will depend on?

Related MCQs

• The rate of heat loss through a furnace wall is 1000 kcal per hour when inside temperature is 1000?C and outside wall temperature is 500?C. What should be the wall thickness in case the thermal conductivity of wall material is 0.5 kcal/m-hr?C
• The face temperatures of a flat wall are 650?C and 450?C respectively and the thermal conductivity of wall material is 0.30 kcal/m-hr-?C. For a wall thickness of 20 cm, the rate of heat conduction per square meter of wall area will be
• The inner wall of a furnace is at a temperature of 700°C. The composite wall is made of two substances, 10 and 20 cm thick with thermal conductivities of 0.05 and 0.1 W.m-1.°C1 respectively. The ambient air is at 30°C and the heat transfer co-efficient between the outer surface of wall and air is 20 W.m-2 .°C-1 . The rate of heat loss from the outer surface in W.m-2 is
• Heat conducted througfi unit area and unit thick face per unit time when temperature difference between opposite faces is unity,is called
• A 10 cm dia steam pipe, carrying steam at 180°C, is covered with an insulation (conductivity = 0.6 W/m.°C). It losses heat to the surroundings at 30°C. Assume a heat transfer co-efficient of 0.8 W/m2 .°C for heat transfer from surface to the surroundings. Neglect wall resistance of the pipe and film resistance of steam. If the insulation thickness is 2 cms, the rate of heat loss from this insulated pipe will be
• The heat flux (from outside to inside) across an insulating wall with thermal conductivity, K = 0.04 W/m.°K and thickness 0.16m is 10 W/m2 . The temperature of the inside wall is - 5°C. The outside wall temperature is
• The surface temperatures of a flat wall are 650?C and 450?C respectively and the thermal conductivity of the wall material is 0.30 kcal/m-hr-?C. The heat flux for a wall of 20 cm thickness will be
• A dimensionless heat transfer coefficient which gives a measure of the ratio of the heat transfer rate to the rate at which heat would be conducted within the fluid under a temperature gradient is known as
• The overall heat transfer co-efficient for a shell and tube heat exchanger for clean surfaces is U0 = 400 W/m2.K. The fouling factor after one year of operation is found to be hd0 = 2000W/m2.K. The overall heat transfer co-efficient at this time is
• The rate of heat transfer through a pipe wall is given by, q = 2π k (Ti- T0)/ln (ri /r0). For cylinder of very thin wall, q can be approximated by