The ratio of permissible shear stress in limit state method oof design and working stress method of design is

Related MCQs

• A simply supported beam 6 m long and of effective depth 50 cm, carries a uniformly distributed load 2400 kg/m including its self weight. If the lever arm factor is 0.85 and permissible tensile stress of steel is 1400 kg/cm2, the area of steel required, is
• Limit state method is based on probable
• In a singly reinforced beam, if the permissible stress in concrete reaches earlier than that in steel, the beam section is called
• The length of lap in tension reinforcement should not be less than the bar diameter × (actual tension / four times the permissible average bond stress) if it is more than
• An R.C.C. beam of 6 m span is 30 cm wide and has a lever arm of 55 cm. If it carries a U.D.L. of 12 t per m and allowable shear stress is 5 kg/cm2, the beam
• Dimensions of a beam need be changed if the shear stress is more than
• The maximum shear stress (qmax) in a rectangular beam is
• For M20 grade of concrete, the maximum shear stress shall not exceed
• The section of a reinforced beam where most distant concrete fibre in compression and tension in steel attains permissible stresses simultaneously, is called
• The maximum permissible size of aggregates to be used in casting the ribs of a slab, is