A swimming pool having one side 10 m long, is filled with water up to 3.6 m depth. Find total pressure on the wall of the pool

Related MCQs

• An inverted triangular plate is having base parallel to water surface with width 1.6 m and height 2.10 m. It is submerged in water in such a way that its base is 1.0 m below free surface. Find total pressure.
• A rectangular plate of 2 m x 3 m height is immersed in water vertically with top edge parallel to and at depth of 3 m below free surface. Calculate total water pressure.
• A water tank contains 1.5 m deep water. Find pressure exerted by water per metre length of the tank.
• A circular plate 2.5 m diameter is immersed in water with its greatest and lowest depth below the free surface being 3.0m and 1.0m respectively. Find the position of centre of pressure
• A 30 cm x 20 cm horizontal venturimeter is placed to measure the flow rate of water. The pressure difference between the inlet and the throat is 2.52 m (of water). Find the flow rate of the venturimeter with a constant of 0.98.
• A pipe line is 6 km long and having 20 cm diameter connect two reservoir 'A' and 'B'. The rate of discharge in the pipe is 30 lit/sec. Find out the difference in reservoir levels if friction factor f = 0.0008.
• When pressure is measured with reference to atmospheric pressure, but it is below atmospheric pressure, it is known as
• Whenever a liquid (such as water, oil etc.) is filled in a vessel, it exerts force at all points on the sides and bottom of the container. This force per unit area is called
• Water is flowing through a rectangular notch, having base width 500 mm and head over it is 160 mm. Find discharge of notch if Cd = 0.6.
• A simple manometer containing mercury is used to measure pressure of oil (sp. gr. 0.8) flowing in a pipe as shown below. Mercury level in open tube is 150 mm higher than that on left limb. If height of oil in left limb is 90 mm, determine the pressure in terms of head of water in a pipe.