The safe working pressure for a spherical vessel 1.5 m diameter and having 1.5 cm thick wall not to exceed tensile stress 50kg/cm2, is

Related MCQs

• The equivalent axial tensile load Pe, which produces an average axial tensile stress in the section equivalent to the combined stress due to axial tension P and bending M, at the extreme fibre of the section, is given by (where Z is the section modulus of the section).
• If fbt and fc are the co-existent bending tensile stress and shear stress in a member, the equivalent stress fc is
• For the buildings having a low permeability, the internal wind pressure acting normal to the wall and roof surfaces is taken as (Where p is basic wind pressure)
• If the area of cross-section of a single angle discontinuous strut is 30 cm2 and allowable working stress corresponding to its slenderness ratio is 625 kg/cm2, the safe load carrying capacity of the member, is
• The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is
• The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is
• The stress in the wall of a thin cylinder subjected to internal pressure, is
• The greatest gauge of long rivets should not exceed (where d is the diameter of the holes).
• The greatest gauge of long rivets should not exceed (where d is the diameter of the holes).
• IS : 800 - 1971 recommends that in a splice plate the number of rivets carrying calculated shear stress through a packing greater than 6 mm thick, is to be increased by 2.5% for every