The maximum permissible slenderness ratio of a member carrying loads resulting from wind, is

Related MCQs

• The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is
• The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is
• A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed
• A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed
• Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is
• Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is
• The maximum slenderness ratio of a compression member carrying both dead and superimposed load is
• The maximum slenderness ratio of a compression member carrying both dead and superimposed load is
• If the area of cross-section of a single angle discontinuous strut is 30 cm2 and allowable working stress corresponding to its slenderness ratio is 625 kg/cm2, the safe load carrying capacity of the member, is
• The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is