The maximum ratio of span to depth of a slab simply supported and spanning in one direction, is

Related MCQs

• The maximum ratio of span to depth of a slab simply supported and spanning in two directions, is
• If the maximum bending moment of a simply supported slab is M Kg.cm, the effective depth of the slab is (where Q is M.R. factor)
• If the sides of a slab simply supported on edges and spanning in two directions are equal, the maximum bending moment is multiplied by
• For a continuous floor slab supported on beams, the ratio of end span length and intermediate span length, is
• If K is a constant depending upon the ratio of the width of the slab to its effective span l, x is the distance of the concentrated load from the nearer support, bw is the width of the area of contact of the concentrated load measured parallel to the supported edge, the effective width of the slab be is
• For normal cases, stiffness of a simply supported beam is satisfied if the ratio of its span to its overall depth does not exceed
• For the design of a simply supported T-beam the ratio of the effective span to the overall depth of the beam is limited to
• The effective span of a simply supported slab, is
• If l1 and l2 are the lengths of long and short spans of a two way slab simply supported on four edges and carrying a load w per unit area, the ratio of the loads split into w1 and w2acting on strips parallel to l2 and l1 is
• The maximum ratio of span to depth of a cantilever slab, is