The increase in the length of a bar of length 1 m, area 300 mm2, modulus of elasticity 2×10^5 N/mm2 due to a tensile load of 120 KN is .

Related MCQs

• An axial pull of 50 KN is suddenly applied to a steel bar 2 m long and 1000 mm2 in cross-section. If modulus of elasticity is 200 GPa, find strain energy stored in the bar
• 3.5 m long bar is under tensile load and due to that increase in length of bar is 1.75 mm then strain =
• steel bar 10 mm x 10 mm cross section is subjected to an axial tensile load of 20kN. If the length of bar is 1 m and E = 200 GPa, then elongation of the bar is:
• During a tensile test on a specimen of 1 cm cross-section, maximum load observed was 8 tonnes and area of cross-section at neck was 0.5 cm2. Ultimate tensile strength of specimen is
• The Young‟s modulus of elasticity of a material is 2.5 times its modulus of rigidity. The Poisson‟s ratio for the material will be
• Euler's formula states that the buckling load P for a column of length l, both ends hinged and whose least moment of inertia and modulus of elasticity of the material of the column are I and E respectively, is given by the relation
• The ultimate shear stress of a mild steel plate of 10 mm thickness is 350 N/mm2. Calculate the diameter of the hole that can be punched to it without exceeding a compressive stress of 700 N/mm2.
• A bar 2 m long and 20 mm diameter is subjected to an axial pull of 125.6 KN. Due to this load, length increases by 4 mm and diameter reduce by 0.012 mm. Find Poison‟s ratio.
• Young‟s modulus of a material which gives 2 kN/mm2 stress at 0.01 strain is
• A simply supported beam 6 m long and of effective depth 50 cm, carries a uniformly distributed load 2400 kg/m including its self weight. If the lever arm factor is 0.85 and permissible tensile stress of steel is 1400 kg/cm2, the area of steel required, is