During a tensile test on a specimen of 1 cm cross-section, maximum load observed was 8 tonnes and area of cross-section at neck was 0.5 cm2. Ultimate tensile strength of specimen is

Related MCQs

• Tensile strength of a material is obtained by dividing the maximum load during the test by the
• A simply supported beam 6 m long and of effective depth 50 cm, carries a uniformly distributed load 2400 kg/m including its self weight. If the lever arm factor is 0.85 and permissible tensile stress of steel is 1400 kg/cm2, the area of steel required, is
• The percentage reduction in area of a cast iron specimen during tensile test would be of the order of
• The length of a column, having a uniform circular cross-section of 7.5 cm diameter and whose ends are hinged, is 5 m. If the value of E for the material is 2100 kN/cm2, the permissible maximum crippling load will be
• In a cantilever subjected to a combination of concentrated load, uniformly distributed load and uniformly varying load, Maximum bending moment is
• The increase in the length of a bar of length 1 m, area 300 mm2, modulus of elasticity 2×10^5 N/mm2 due to a tensile load of 120 KN is .
• 3.5 m long bar is under tensile load and due to that increase in length of bar is 1.75 mm then strain =
• steel bar 10 mm x 10 mm cross section is subjected to an axial tensile load of 20kN. If the length of bar is 1 m and E = 200 GPa, then elongation of the bar is:
• Which type of load is applied in tensile testing?
• A composite section of R.C.C. column 300mm×300mm in section having 20mm diameter 4 bars, one at each corner. Strength of concrete is 5 N/mm2 and modular ratio Es/Ec=9. Calculate load taken by column.