Of the two prismatic beams of same material, length and flexural strength, one is circular and other is square in cross-section. The ratio of weights of circular and square beams is

Related MCQs

• Two beams, one of circular cross-section and the other of square cross-section, have equal areas of cross-sections. When these beams are subjected to bending.
• Two shafts of the same material are subjected to the same torque. If the first shaft is of solid circular section and the second shaft is of hollow section whose internal diameter is 2/3 of the outside diameter, the ratio of weights of hollow shaft to solid shaft would be
• A solid circular shaft and a thin walled circular tube made of the same material and having the same weight are stressed in torsion to the same maximum shear stress. The ratio of the amounts of strain energy stored in the two shafts would be
• Two beams carrying uniformly distributed load have same depth but beams A has width 2nd as compared to width w for beam B. The ratio of elastic strength of beam A compred to that of B will be
• The change in length of a rod of uniform circular cross section was found to be 2 mm for some applied force. The change in length of a rod of the same material and length but of half the diameter subjected to the same force will be Mm
• Slenderness ratio of a 5 m long column hinged at both ends and having a circular crosssection with diameter 160 mm is
• Two cantilever beams are of equal length. One carries a uniformly distributed load and other carries same load but concentrated at the free end. The ratio of maximum deflection is
• Two beams, one of circular cross-section and other of square cross-section, have equal areas of cross-section. If subjected to bending
• Two beams of equal cross-sectional area are subjected to equal bending moment. If one beam has square cross-section and the other has circular section, then
• The ratio of the area under the bending moment diagram between any two points along a beam to the flexural rigidity EI gives the change to the following parameter between the two points