McqMate

Q. |
## The equivalent coefficient of friction for a cone clutch is ____. |

A. | µ sinα |

B. | µ tanα |

C. | µ/sinα |

D. | µ/tanα |

Answer» C. µ/sinα |

2.6k

0

Do you find this helpful?

36

View all MCQs in

Theory of MechanicsNo comments yet

- Determine the axial force required to engage a cone clutch transmitting 25 kW power at 750 rpm. Average friction diameter of the cone is 400 mm, semicone angle 10 degree and coefficient of friction 0.25.
- Determine the axial force required to engage a cone clutch transmitting 25 kW power at 750 rpm. Average friction diameter of the cone is 400 mm, semicone angle 60 degree and coefficient of friction 0.25.
- A conical pivot supports a load of 20 kN, and its semicone angle is 41.81 degree. The friction coefficient is 0.06 and shaft runs at 200 rpm. The torque required to overcome friction and power lost in friction is
- In multiple friction clutch, the number of active friction surfaces is ____.
- A thrust bearing having collars of external and internal diameter as 40 cm and 20 cm respectively, carries an axial load of 3000 N. The co-efficient of friction is 0.09 and shaft runs at 420 rpm. The power lost in friction is to be determined. The corresponding value of friction torque would be ____.
- In case of cone clutch, power transmission is same as that of________
- The frictional torque transmitted by a cone clutch is same as that of ____.
- Following are the details pertaining to thrust bearing 1) External and internal dia of contacting surfaces-320 mm and 200 mm resp. 2) Axial load-80 kN 3)Pr. Intensity-350 kN/m2 4) shaft speed-400 rpm 5)coefficient of friction-0.06 Calculate power lost in overcoming friction. the frictional torque and power lost in frictional
- A friction clutch should be designed on the assumption of
- Considering the safe design, the friction clutch should be designed _______