A friction clutch should be designed on the assumption of

Related MCQs

• Considering the safe design, the friction clutch should be designed _______
• In multiple friction clutch, the number of active friction surfaces is ____.
• Determine the axial force required to engage a cone clutch transmitting 25 kW power at 750 rpm. Average friction diameter of the cone is 400 mm, semicone angle 10 degree and coefficient of friction 0.25.
• Determine the axial force required to engage a cone clutch transmitting 25 kW power at 750 rpm. Average friction diameter of the cone is 400 mm, semicone angle 60 degree and coefficient of friction 0.25.
• A thrust bearing having collars of external and internal diameter as 40 cm and 20 cm respectively, carries an axial load of 3000 N. The co-efficient of friction is 0.09 and shaft runs at 420 rpm. The power lost in friction is to be determined. The corresponding value of friction torque would be ____.
• A conical pivot supports a load of 20 kN, and its semicone angle is 41.81 degree. The friction coefficient is 0.06 and shaft runs at 200 rpm. The torque required to overcome friction and power lost in friction is
• Torque transmitted by single plate clutch with axial spring load = 1 kN, and inner and outer radii of 10 cm and 15 cm and µ = 0.5 with assumption of uniform wear is ____.
• The equivalent coefficient of friction for a cone clutch is ____.
• Which of the following is an example of friction clutch?
• Friction torque transmitted by a disc or plat clutch is same as that of ____.