………….Load is one which is considered to act at a point.

Related MCQs

• A uniformly distributed load may be assumed to behave like a point load at the centre of gravity of the load for all sorts of calculations.
• There is always a limiting value of load up to which the strain totally disappears on the removal of load; the stress corresponding to this load is called…………
• A load which acts at a point on a beam is not called uniformly distributed load.
• If the working load is one third of the ultimate load, the factor of safety is
• When both ends of a column are fixed, the crippling load is P. If one end of the column is made free, the value of crippling load will be changed to
• A solid circular shaft of diameter D carries are axial load W. If the same load is applied axially on a hollow circular shaft of inner diameter D/2, the ratio of stress in a solid shaft to a hallow one is
• Two cantilever beams are of equal length. One carries a uniformly distributed load and other carries same load but concentrated at the free end. The ratio of maximum deflection is
• A short column of external diameter of 250 mm and internal diameter of 150 mm carries an eccentric load of 1000 kN. The greatest eccentricity which the load can have without producing tension anywhere is
• the extension per unit length of the rod due to suddenly applied load as compare to same load gradually applied to same rod is
• If a prismatic member with area of cross-section A is subjected to a tensile load P, then the maximum shear stress and its inclination with the direction of load respectively are