……….represents the resistance developed by a unit area of cross section.

Related MCQs

• Two beams, one of circular cross-section and other of square cross-section, have equal areas of cross-section. If subjected to bending
• A steel bar ABC (E = 200 GPa) is 1 m long. For AB = 0.7 m, it has cross section P area of 500 mm2 and for BC = 0.3 m the cross section area is 400 mm2. The bar is subjected to an axial pull of 100 kN. The stress is maximum in ___ _
• A stepped bar of steel consists of a pmormtion with cross section area 500 mm2 connected to a portion with cross section area 1000 2. Each portion has a length of 1 m. The modulus of elasticity of steel is 200 GPa. The maximum elongation of the bar by applying an axial tensile force at the ends without exceeding a stress of 100 MPa is    mm.
• Two beams, one of circular cross-section and the other of square cross-section, have equal areas of cross-sections. When these beams are subjected to bending.
• A prismatic steel bar 25 cm long is subjected to axial compressive force of 2000 kg. For steel E = 2 x 106 kg/cm2. The ratio of strain energy when the cross-sectional area is 25 sq. cm to that when the cross-section area is 12.5 sq cm, would be
• The change in length of a rod of uniform cross section was found to be 2 mm for some applied force. The change in length of a rod of the same material and length but of twice the cross section area subjected to the same force will be__ mm.
• Two beams of equal cross-sectional area are subjected to equal bending moment. If one beam has square cross-section and the other has circular section, then
• The area around the centre of gravity of a cross-section within which any load applied will produce stress of only one sign throughout the entire cross-section, is known as
• Whenever some external system of forces acts on a body, it undergoes some deformation. As the body undergoes some deformation, it sets up some resistance to the deformation. This resistance per unit area to deformation, is called
• The longitudinal stress developed in a rod of cross section area 50 mm2 is 100 MPa. The force acting along its axis is -------