Why is a decoupling capacitor needed for TTL ICs and where should it be connected

Related MCQs

• The most common TTL series ICs are:
• Why is a pull-up resistor needed when connecting TTL logic to CMOS logic?
• A TTL NAND gate with IIL(max) of –1.6 mA per input drives eight TTL inputs. How much current does the drive output sink?
• It is best not to leave unused TTL inputs unconnected (open) because of TTL's
• One advantage TTL has over CMOS is that TTL is
• Ten TTL loads per TTL driver is known as:
• What causes low-power Schottky TTL to use less power than the 74XX series TTL?
• An output gate is connected to four input gates; the circuit does not function. Preliminary tests with the DMM indicate that the power is applied; scope tests show that the primary input gate has a pulsing signal, while the interconnecting node has no signal. The four load gates are all on different ICs. Which instrument will best help isolate the problem?
• In a TTL circuit, if an excessive number of load gate inputs are connected,
• What are the major differences between the 5400 and 7400 series of ICs?